Anisotropy in the tensile behaviour of Ti-6Al-2Sn-4Zr-6Mo alloy

Authors

  • M. Corzo Departamento de Ciencia de Materiales e Ingeniería Metalúrgica, Universitat Politécnica de Catalunya
  • J. M. Mañero Departamento de Ciencia de Materiales e Ingeniería Metalúrgica, Universitat Politécnica de Catalunya
  • M. Anglada Departamento de Ciencia de Materiales e Ingeniería Metalúrgica, Universitat Politécnica de Catalunya
  • A. Mateo Departamento de Ciencia de Materiales e Ingeniería Metalúrgica, Universitat Politécnica de Catalunya

DOI:

https://doi.org/10.3989/revmetalm.2005.v41.iExtra.1064

Keywords:

Ti-6246, Mechanical Properties, Texture, Deformation

Abstract


Tensile properties were evaluated for a Ti-6Al-2Sn-4Zr-6Mo alloy forged, in the β state age-hardening state and further double ageing treatment. Since this alloy tends to exhibit a strong anisotropy in the mechanical behaviour, the study has been realized in the radial and tangential direction relative to the forging axis. An anomalous tendency was observed in the tensile test, characterized by low yield strength and a high ductility in the radial direction. This effect was analyzed by transmission electron microscopy and X-ray diffraction. The phase transformation to martensite induced by deformation, the mechanical deformation by twinning and the presence of α-phase along the grain boundary of the colonies (b-prior) are the reasons for this anomalous tendency.

Downloads

Download data is not yet available.

Downloads

Published

2005-12-17

How to Cite

Corzo, M., Mañero, J. M., Anglada, M., & Mateo, A. (2005). Anisotropy in the tensile behaviour of Ti-6Al-2Sn-4Zr-6Mo alloy. Revista De Metalurgia, 41(Extra), 401–406. https://doi.org/10.3989/revmetalm.2005.v41.iExtra.1064

Issue

Section

Articles