Cyclic and isothermal oxidation behavior of 2.25Cr-1Mo steel

Authors

  • Manuel Proy Dpto. de Ciencia e Ingeniería de Materiales, Universidad Rey Juan Carlos
  • M Victoria Utrilla Dpto. de Ciencia e Ingeniería de Materiales, Universidad Rey Juan Carlos
  • Enrique Otero Dpto. de Ciencia e Ingeniería de Materiales, Universidad Rey Juan Carlos

DOI:

https://doi.org/10.3989/revmetalm.003

Keywords:

Boiler steel, High temperature corrosion, Kinetic law, Thermal cycling

Abstract


Cyclic and isothermal oxidation of chromium-molybdenum steel 2.25Cr-1Mo were analyzed at 550 °C and 650 °C during 360 hours in air atmospheres. The cycles were performed with two stages; one of heating in furnace during 90 minutes and then the sample were cooled to 50 °C by air flow. Thermogravimetric analyses were performed to obtain high temperature corrosion kinetics. Several characterization techniques have been used to identify the corrosion mechanism, as X-Ray Diffraction (XRD), Optical Microscopy (OM) and Scanning Electron Microscopy (SEM). Thermal cycling tests can changes the corrosion mechanism, due cracks propagation in oxide scale, that witch can favors the access of oxidant agent to the substrate.

Downloads

Download data is not yet available.

References

Buscail, H., Caudron, E., Cueff, R., Issartel, C., Perrier, S. y Riffard, F. 2003. Yttrium sol-gel coating effects on the cyclic oxidation behaviour of 304 stainless steel. Corros. Sci. 45 (12), 2867–2880. http://dx.doi.org/10.1016/S0010-938X(03)00114-8

Chen, R.Y., Yuen, W.Y.D. 2010. Short-time Oxidation Behavior of Low-carbon, Low-silicon Steel in Air at 850-1,180 °C-III: Mixed Linear-and-Parabolic to Parabolic Transition Determined Using Local Mass-Transport Theories. Oxid. Met. 74 (5–6), 353–373. http://dx.doi.org/10.1007/s11085-009-9180-z

Gardiner, D.J., Littelton, C.J. y Thomas, K.M. 1987. Distribution and characterization of high temperature air corrosion products on iron-chromium alloys by Raman microscopy. Oxid. Met. 27 (1–2), 57–72. http://dx.doi.org/10.1007/BF00656729

Hanesch, M. 2009. Raman spectroscopy of iron oxides and (oxy) hidroxides at low laser power and possible applications in environmetal magnetic studies. Geophys. J. Int. 177 (3), 941–948. http://dx.doi.org/10.1111/j.1365-246X.2009.04122.x

Henry, J.F., Tanzosh, J., Stanko, G., Shingledecker, J., Vitalis, B., Purgert, R. y Viswanathan, R. 2005. U.S. program on materials technology for ultra-supercritical coal power plants. J. Mater. Eng. Perform. 14 (3), 281–292. http://dx.doi.org/10.1361/10599490524039

Muddle, B.C. y Singh Raman, R.K. 2002. High temperature oxidation in the context of life assessment and microstructural degradation of weldments of 2.25Cr–1Mo steel. Int. J. Pres. Ves. Pip. 79 (8–10), 585–590.

Sarver, J., Tanzosh, J.M. y Viswanathan, R. 2006. Boiler materials for ultra-supercritical coal power plants-Steamside oxidation. J. Mater. Eng. Perform. 15 (3), 255–274. http://dx.doi.org/10.1361/105994906X108756

Seifert, W., Thomas, R. y Rhede, D.F. 2010. Origin of coexisting wustite, MgFe and REE phosphate minerals in graphite-bearing fluorapatite from the Rumburk granite. Eur. J. Mineral. 22 (4), 495–507. http://dx.doi.org/10.1127/0935-1221/2010/0022-2034

Viswanathan, R. y Bakker, W. 2001. Materials for ultrasupercritical coal power plants-Boiler materials: Part 1. J. Mater. Eng. Perform. 10 (1), 81–95. http://dx.doi.org/10.1361/105994901770345394

Wu, X., Kuang, W., Han, E.H., Rao, J. 2011. The mechanism of oxide film formation on Alloy 690 in oxygenated high temperature water, Corros. Sci. 53 (11), 3853–3860. http://dx.doi.org/10.1016/j.corsci.2011.07.038

Xie Y., Wang M., Zhang G. y Chang M. 2006. Analysis of superalloy turbine blade tip cracking during service. Eng. Fail. Anal. 13 (8), 1429–1436. http://dx.doi.org/10.1016/j.engfailanal.2005.07.022

Yoon, K.B. y Jeong, D.G. 1999. Oxidation failure of radiant heater tubes. Eng. Fail. Anal. 6 (2), 101–112. http://dx.doi.org/10.1016/S1350-6307(98)00033-8

Yoshinaga M., Kishimoto H., Yamaji K., Brito M.E., Xiong Y., Yokokawaza H. y Horita T. 2011. Effects of Thermal Cycling on the Formation of Oxide Scale of Fe–Cr Alloy Interconnects for Solid Oxide Fuel Cells. Int. J. Appl. Ceram. Technol. 8 (6), 1374–1381. http://dx.doi.org/10.1111/j.1744-7402.2010.02600.x

Young, D.J. 2008. High Temperature oxidation an corrosion of metals, Ed. Elsevier, Amsterdam, Holanda, pp. 497–498.

Published

2014-03-30

How to Cite

Proy, M., Victoria Utrilla, M., & Otero, E. (2014). Cyclic and isothermal oxidation behavior of 2.25Cr-1Mo steel. Revista De Metalurgia, 50(1), e003. https://doi.org/10.3989/revmetalm.003

Issue

Section

Articles