Copper alloys deterioration due to anthropogenic action

A. Duran; J. L. Pérez-Rodríguez; L. K. Herrera; M. C. Jiménez-de-Haro; M. D. Robador; A. Justo; J. M. Blanes; J. C. Pérez-Ferrer

doi:10.3989/revmetalm.2008.v44.i1.98

Authors

A. Duran Instituto de Ciencia de Materiales de Sevilla, CSIC.
J. L. Pérez-Rodríguez Instituto de Ciencia de Materiales de Sevilla, CSIC.
L. K. Herrera Instituto de Ciencia de Materiales de Sevilla, CSIC.
M. C. Jiménez-de-Haro Instituto de Ciencia de Materiales de Sevilla, CSIC.
M. D. Robador Instituto de Ciencia de Materiales de Sevilla, CSIC.
A. Justo Instituto de Ciencia de Materiales de Sevilla, CSIC.
J. M. Blanes Instituto de Ciencia de Materiales de Sevilla, CSIC.
J. C. Pérez-Ferrer Instituto de Ciencia de Materiales de Sevilla, CSIC.

DOI:

https://doi.org/10.3989/revmetalm.2008.v44.i1.98

Keywords:

Deterioration, Bronze, Brass, Cleaning, Human action

Abstract

Results are presented from several samples taken from leaves of the Pardon Portico of Mosque-Cathedral of Cordoba, where an alteration on their surface was detected. Metal samples analyzed using X-ray microanalysis and powder xray diffraction were predominantly constituted by copper with some amounts of zinc attributed to brass, whereas other samples were also constituted by copper, tin and lead attributed to bronze. Surface samples were analyzed using the same techniques. In addition Fourier transform infrared spectroscopy was also used.The main compound identified in all the surface of the leaves is copper chloride hydroxide (atacamite). Lead chlorides have also been found. These data show that the sudden alteration that appears may be attributed to the use of some cleaning product containing chloride. Other compounds detected in the surface were gypsum, quartz and oxalates coming from environmental contamination.

Downloads

Download data is not yet available.

References

[1] L. Uller, H. Videla and L.K. Herrera, Proc. LatinCorr, paper nº 124, ABRACO (Eds.), Rio de Janeiro, Brasil, 2006.

[2] E. Mattson and R. Holm, Atmos. Corros. (1982) 365-382.

[3] P. Eriksson, L. Johansson and J. Gullman, Corros. Sci. 34 (1993) 1083-1097. doi:10.1016/0010-938X(93)90290-W

[4] J.D. Meakin, D.L. Amest, D.A. Dolske, Atmos. Environ. 26B (1992) 207-215.

[5] G. Lanterna, Thermochim. Acta 269/270 (1995) 729-742. doi:10.1016/0040-6031(95)02668-1

[6] L.S. Selwyn, N.E. Binnie, J. Poitras, M.E. Laver and D.A. Downham, Stud. Conserv. 41 (1996) 205-228. doi:10.2307/1506541

[7] A.E. Cepero, Proc. 6th Int. Cong. Cultural Heritage and Conservation, paper nº 37, Cencrem (Eds.), La Habana, Cuba, 2002

[8] M. Morcillo and M.E.M. Almeida, Corrosión y protección de metales en las atmósferas de Iberoamérica (M. Morcillo et al., Eds), 1998, pp. 547-590.

[9] A. Lins, Sculptural Monuments in an Outdoor Environment, V.N. Naude (Ed.), Pennsylvania Academy of the Fine Arts, Philadelphia PA, 1985, pp. 8-20.

[10] M.C. Jiménez De Haro, Á. Justo, A. Durán, M.B. Sigüenza and J.L. Pérez-Rofigure Dríguez, Air Pollution and Cultural Heritage, C. Saiz-Jimenez (Ed.) Balkema Publishers. London, 2004, pp 79-84.

[11] D.M. Bastidas, I. Cayela and J.M. Bastidas, Rev. Metal. Madrid 42 (2006) 367-381.

[12] G. P. Bernardini, M. Corazza, F. Olmi, C. Sabell, Squarcia Lupi, M. C. Squarcia Lupi and R. Trosti-Ferroni, Sci. Technol. Cultural Heritage 1 (1992) 177-189.

[13] J. Barrios-Neira, L. Montealegre, M. Nieto and J. Palma, Applied Study of Cultural Heritage and Clays, J.L. Pérez Rodríguez (Ed.), Consejo Superior de Investigaciones Científicas (2003) pp. 29-46.

[14] T.E. Groedel, J.Electrochem. Soc. 136 (1993) 193C-203C. doi:10.1149/1.2096868

[15] S.E. Dunkle, Doctoral Thesis (PhD), Faculty of the Virginia Polytechnic Institute, EE. UU., 2002.

[16] S. Steiberg, K. Kawamura and I.R. Kaplam, Int. J. Environ. Anal. Chem. 19 (1985) 251-260. doi:10.1080/03067318508077036

[17] M. Del Monte, C. Sabbioni and G. Zappia, Sci. Total Environ. 67 (1987) 17-39. doi:10.1016/0048-9697(87)90063-5