Effect of the physical properites of activated carbon in the gold adsorption from cyanide media

Authors

  • P. Navarro Departamento de Ingeniería Metalúrgica, Facultad de Ingeniería, Universidad de Santiago de Chile (USACH)
  • C. Vargas Departamento de Ingeniería Metalúrgica, Facultad de Ingeniería, Universidad de Santiago de Chile (USACH)

DOI:

https://doi.org/10.3989/revmetalm.0929

Keywords:

Physical properties, Activated carbon, Adsorption, Gold

Abstract


The effect of the physical properties of an activated carbon such as pore size distribution, specific surface, pore average diameter, in the gold adsorption from cyanide solution with the gold to the Au (CN)2 form, was studied. To meet the proposed objectives two carbons were studied: carbon A with specific surface of 985 m2 / g, 57 % of micropores and 1.85 nm as average diameter of pores and carbon B with specific surface of 786 m2 / g, 27 % and pores of 2.35 nm as average diameter of pores; both granular carbons made from coconut shell. Batch adsorption tests were performed in a reactor of 500 ml of capacity with mechanical stirring at constant temperature. The effect of cations present in the aqueous solutions such as Ca2+, Na+, K+ and Li+, the effect of pore size distribution, the effect of average pore diameter and surface area were evaluated in function of the rate and amount of gold adsorbed on the activated carbons denominated as A and B. The results to indicate that the physical properties of an activated carbon are an important factor in the gold adsorption process in terms of rate and amount of adsorbed gold. The carbon B with 786 m2 / g of specific surface area reached a higher load per unit area (0.02 mg Au/m2) in relation to the carbon B of 985 m2 / g which had a load of 0.01 mg Au / m2, after 6 h of contact carbon-solution. The rate adsorption of gold in both carbons is controlled by mass transfer in the liquid film surrounding the carbon particles to short times or small loads of gold in the particles, far from equilibrium. Applying a first order kinetic model, it was obtained that the ratio of the kinetic constants for carbons A and B, ie (kB / kA), fluctuates in a value of 3 for the different cations in study. In general it is possible to say that the rate adsorption and the amount of adsorbed gold increased with the increase in macropores and with the increasing pore average diameter. The presence of cations favors the gold adsorption in cyanide media, especially those of higher valence.

Downloads

Download data is not yet available.

References

[1] R. Merello y G. Zárate, Minerales 42 (1985) 25-39.

[2] C. Fleming,Hydrometallurgy 30 (1992) 127-162. doi:10.1016/0304-386X(92)90081-A

[3] J. Marsden y L. House, The Chemistry of Gold Extraction, 2ª ed. SME, 2006, pp. 260-266.

[4] G. Mc Dougall y R. Hancock, Gold Bulletin 14 (1981) 138-153.

[5] G. Mc Dougall, J. S. Afr. I. Min. Metall. 91 (1991) 109-120.

[6] R. J. Davidson, J. S. Afr. I. Min. Metall. 75 (1974) 67-74.

[7] G. Mc Dougall, R. Hancock, M. Nicol, O. Wellington y R. Copperthwaite, J. S. Afr. I. Min. Metall. 80 (1980) 344-356.

[8] V. López, C. Moreno, J. Rivera y L. Radovic, Carbon 41 (2002), 2.020-2.022.

[9] M. Adams y C. Fleming, Metall. Mater. Trans. B. 20 (1989) 315-325.

[10] M. Adams, Hydrometallurgy 25 (1990) 171-184. doi:10.1016/0304-386X(90)90037-3

[11] M. Adams, J. S. Afr. I.Min. Metall. 90 (1990) 37-44.

[12] M. Adams, J. Friedl y F.Wagner, Hydrometallurgy 37 (1995) 33-45. doi:10.1016/0304-386X(94)00017-W

[13] K. Rees, J. Van Deventer, Hydrometallurgy 58 (2000) 151-167. doi:10.1016/S0304-386X(00)00130-4

[14] M. Yalcin y A. Arol, Hydrometallurgy 63 (2002) 201-206. doi:10.1016/S0304-386X(01)00203-1

[15] E. Cho y C. Pitt, Metall. Mater. Trans. B. 10 (1979) 165-169.

[16] E. Cho, S. Dixon y C. Pitt,Metall.Mater. Trans. B. 10 (1979) 185-189.

[17] N. Tsuchida y D. Muir, Metall. Mater. Trans. B. 17 (1986) 529-533.

[18] M. Fuerstenau, C. Nebo, J. Kelso y R. Zaragoza, Miner. Metall. Process. 4 (1987) 177-181.

[19] P. Van der Merwe y J. Van Deventer, Chem. Eng. Comm. 65 (1988) 121-138. doi:10.1080/00986448808940248

[20] W. Jones y H. Linge, Hydrometallurgy 22 (1989) 231-238. doi:10.1016/0304-386X(89)90053-4

[21] R. Jordi, B. Young y A. Bryson, Chem. Eng. Comm. 102 (1991) 127-147. doi:10.1080/00986449108910853

[22] F. Petersen y J. Van Deventer, Chem. Eng. Science. 46 (1991) 3.053-3.065.

[23] J. Van Deventer y P. Van Der Merwe, Metall. Mater. Trans. B. 24 (1993) 433-440.

[24] W. Yapu,M. Segarra,M. Fernandez y F. Espiell, Metall. Mater. Trans. B. 25 (1994) 185-191. doi:10.1007/BF02665201

[25] N. Vegter y R. Sanderbergh, J. S. Afr. I. Min. Metall. 96 (1996) 109-118.

[26] J. Van Deventer, Chem. Eng. Comm. 44 (1986) 257-274. doi:10.1080/00986448608911359

[27] G. Mc Dougall, M. Adams y R. Hancock, Hydrometallurgy 18 (1987) 125-138. doi:10.1016/0304-386X(87)90024-7

[28] M. Adams, G. Mc Dougall y R. Hancock, Hydrometallurgy 18 (1987) 139-154. doi:10.1016/0304-386X(87)90025-9

[29] M. Adams, G. Mc Dougall y R. Hancock, Hydrometallurgy 19 (1987) 95-115. doi:10.1016/0304-386X(87)90044-2

[30] L.Woollacott,W. Stange y R. King, J. S. Afr. I. Min. Metall. 90 (1990) 275-282.

[31] J. Le Roux, A. Bryson y B. Young, J. S. Afr. I. Min. Metall. 91 (1991) 95-103.

[32] N. Vegter, Hydrometallurgy 30 (1992) 229-242. doi:10.1016/0304-386X(92)90086-F

[33] F. Ahmed, B. Young y A. Bryson, Hydrometallurgy 30 (1992) 257-275. doi:10.1016/0304-386X(92)90088-H

[34] N. Syna yM. Valix,Miner. Eng. 16 (2003) 421-427.

[35] P. Sibrell y J. Miller, Miner. Metall. Proc. 9 (1992) 189-195.

[36] A. Ibrado y D. Fuersteanau, Hydrometallurgy 30 (1992) 243-256. doi:10.1016/0304-386X(92)90087-G

[37] M. Seke, R. Sandenbergh y N. Vegter, Miner. Eng. 13 (2000) 527-540. doi:10.1016/S0892-6875(00)00033-9

Downloads

Published

2010-06-30

How to Cite

Navarro, P., & Vargas, C. (2010). Effect of the physical properites of activated carbon in the gold adsorption from cyanide media. Revista De Metalurgia, 46(3), 227–239. https://doi.org/10.3989/revmetalm.0929

Issue

Section

Articles

Most read articles by the same author(s)

1 2 > >>