Electrochemical noise transient analysis for 316 and Duplex 2205 stainless steels in NaCl and FeCl

Authors

  • F. Almeraya-Calderón Universidad Autónoma de Nuevo León (UANL). Facultad de Ingeniería Mecánica y Eléctrica (FIME) - Centro de Investigación e Innovación en Ingeniería Aeronáutica (CIIIA) - Centro de Investigación en Materiales Avanzados S.C (CIMAV), Departamento de Integrida
  • F. Estupiñán Centro de Investigación en Materiales Avanzados S.C (CIMAV), Departamento de Integridad y Diseño de Materiales Compuestos - Grupo Corrosión
  • P. Zambrano R Universidad Autónoma de Nuevo León (UANL). Facultad de Ingeniería Mecánica y Eléctrica (FIME) - Centro de Investigación e Innovación en Ingeniería Aeronáutica (CIIIA)
  • A. Martínez-Villafañe Centro de Investigación en Materiales Avanzados S.C (CIMAV), Departamento de Integridad y Diseño de Materiales Compuestos - Grupo Corrosión
  • A. Borunda T Centro de Investigación en Materiales Avanzados S.C (CIMAV), Departamento de Integridad y Diseño de Materiales Compuestos - Grupo Corrosión
  • R. Colás O Universidad Autónoma de Nuevo León (UANL). Facultad de Ingeniería Mecánica y Eléctrica (FIME) - Centro de Investigación e Innovación en Ingeniería Aeronáutica (CIIIA)
  • C. Gaona-Tiburcio Universidad Autónoma de Nuevo León (UANL). Facultad de Ingeniería Mecánica y Eléctrica (FIME) - Centro de Investigación e Innovación en Ingeniería Aeronáutica (CIIIA)

DOI:

https://doi.org/10.3989/revmetalm.1166

Keywords:

Pitting corrosion, Electrochemical noise, Electrochemical Techniques, Stainless steel austenitic 316, SS Duplex 2205

Abstract


This work shows the results obtained from electrochemical noise measurements for different materials exhibiting pitting corrosion. The transients presented in the potential and current time, correlates with the scanning electron microscopy (SEM) surface analysis. Electrochemical measurements were made at different exposure times to obtain the correlation. The materials used were stainless steel austenitic 316 and duplex 2205, immersed in ferric chloride (FeCl3) and sodium chloride (NaCl) electrolytes. SEM analysis shows that the transients observed in the time series, really correspond to the activity of pit nucleation developed over the surface of the electrodes.

Downloads

Download data is not yet available.

References

[1] P. Marcus e I. Olefjord, Corros. Sci. 28(1988) 589. http://dx.doi.org/10.1016/0010-938X(88)90026-1

[2] Omar A. Hazzazi, Ayman M. Zaky, Mohammed A. Amin y Sayed S. Abd El Rehim, Int. J. Electrochem. Sci. 3 (2008) 489-508.

[3] Z. Szklarska-Smialowska., Pitting Corrosion of Metals, National Association of Corrosion Engineers, Houston, Texas, EE.UU, 1986, p. 1.

[4] K. Darowicki, A. Mirakowski, S. Krakowiak, Corros. Sci. 45 (2003) 1.747-1756.

[5] A. Pardoa, M.C. Merinoa, A.E. Coyb, F. Viejob, R. Arrabalb y E. Matykinab, Corros. Sci. 6 (2008) 1.796-1800.

[6] E. Sarmiento, J. G. González-Rodriguez, J. Uruchurtu, O.Sarmiento, M. Menchaca, Int. J. Electrochem. Sci. 4 (2009) 144-155.

[7] M. G. Pujar, T. Anita, H. Shaikh, R. K. Dayal y H. S. Khatak, Int. J. Electrochem. Sci. 2 (2007) 301-310.

[8] U. Bertocci y F. Huet, Corrosion 51 (1995) 131. http://dx.doi.org/10.5006/1.3293585

[9] U. Bertocci, C. Gabrielli. F. Huet, y M. Keddam, J. Electrochem. Soc. 144, (1997) 31. http://dx.doi.org/10.1149/1.1837361

[10] P. R. Roberge, Corrosion, 50 (1994) 502. http://dx.doi.org/10.5006/1.3294350

[11] G. Gusmano, G. Montespereli, S. Pacetti, A. Petitti, y A. D’Amico, Corrosion 53 (1997) 860. http://dx.doi.org/10.5006/1.3290271

[12] J. W. Isaac y K. R. Hebert, J. Electrochem. Soc. 146 (1999) 502. http://dx.doi.org/10.1149/1.1391635

[13] C. Monticelli, G. Brunoro, A. Frignani, y G. Trabanelli, J. Electrochem. Soc. 139 (1992) 706. http://dx.doi.org/10.1149/1.2069288

[14] R. A. Cottis, M. A. Al-Ansari, G. Bagley, y A. Pettiti, Mater. Sci. Forum 289-292 (1998) 741. http://dx.doi.org/10.4028/www.scientific.net/MSF.289-292.741

[15] K. Hladki and J.L. Dawson, Corros. Sci. 3 (1982) 231-237. http://dx.doi.org/10.1016/0010-938X(82)90107-X

[16] S. Girija, U. Kamachi Mudali, V.R. Raju, R.K. Dayal, H.S. Khatak y Baldeb Raj., Mat. Sci. Eng. 407 (2005) 188. http://dx.doi.org/10.1016/j.msea.2005.07.022

[17] J. Smulko, K. Darowicki y A. Zielinski, Elect. Comm. 4 (2002) 388. http://dx.doi.org/10.1016/S1388-2481(02)00317-X

[18] Helmuth Sarmiento Klapper y Joachim Goellner, Corros. Sci. 51 (2009) 144-150. http://dx.doi.org/10.1016/j.corsci.2008.10.009

[19] ASTM International, G 199-09, Standard Guide for Electrochemical Noise Measurement, ASTM International 2009, pp. 14-20.

[20] F.M. Almeraya-Calderon. Ph. D. Thesis. Centro de Investigación en Materiales Avanzados. S. C., Chihuahua, Chi, México. 1998.

[21] U. Bertocci, J electrochem.l Soc. 128 (1981) 520. http://dx.doi.org/10.1149/1.2127449

[22] Helmuth Sarmiento Klapper, Joachim Goellner y Andreas Heyn, Corros.Sci. 52 (2010) 1.362-1.372.

[23] L. Speckert y G.T. Burstein, Corros. Sci. 53 (2011) 534-539. http://dx.doi.org/10.1016/j.corsci.2010.11.008

[24] J. A. Wharton, R. J. K. Wood y B. G. Mellor, Corros. Sci. 45 (2003) 97-122. http://dx.doi.org/10.1016/S0010-938X(02)00140-3

[25] U. Bertocci y J. Kruger, Surf. Sci. 101 (1980) 608. http://dx.doi.org/10.1016/0039-6028(80)90653-6

[26] Botana Pedemonte, M. Marcos Bárcena y A. Aballe Villero, Ruido Electroquímico, Métodos de Análisis, Septem Ediciones, Oviedo, España, 2002, p. 25.

[27] F. Barragán, R. Guardián, C. Menchaca, I. Rosales y J. Uruchurtu, Int. J. Electrochem. Sci. 5 (2010) 1.799 – 1.809.

[28] J. R. Kearns, J. R. Scully, P. R. Roberge, D.L. Reichert y J. L. Dawson, Electrochemical Noise Measurement, for Corrosion Applications, STP1277, ASTM 1996, pp. 206-208. http://dx.doi.org/10.1520/STP1277-EB

[29] R. Urzua, J. Siqueiros, L. Morales, I. Rosales y J. Uruchurtu, Portugaliae Electrochim. Acta, 27 (2009) 127.

[30] M. Stern., A. Geary, Journal Electrochem. Soc. 104 (1957) 56. http://dx.doi.org/10.1149/1.2428496

[31] Kelly, Inman y Hudson., Electrochemical Noise Measurement for Corrosion Applications, ASTM SP-1277. ASTM 1996, pp. 34-49.

Downloads

Published

2012-04-30

How to Cite

Almeraya-Calderón, F., Estupiñán, F., Zambrano R, P., Martínez-Villafañe, A., Borunda T, A., Colás O, R., & Gaona-Tiburcio, C. (2012). Electrochemical noise transient analysis for 316 and Duplex 2205 stainless steels in NaCl and FeCl. Revista De Metalurgia, 48(2), 147–156. https://doi.org/10.3989/revmetalm.1166

Issue

Section

Articles

Most read articles by the same author(s)