α↔β transformation, mechanical properties and microestructural characterization of Ti-6Al-6V-2Sn alloy
DOI:
https://doi.org/10.3989/revmetalm.2005.v41.iExtra.1075Keywords:
Titanium, Heat treating, Transformation, Differential thermal analisys, Dilatometry, Mechanical propertiesAbstract
In Ti-6Al-6V-2Sn alloy, α↔β transformation kinetics and other transformation characteristics, as well as its influence on subsequent cooling transformations, have been evaluated by differential and dilatometric thermal analysis, hardness measurements and metallographic observation, after performing controlled thermal treatments. Starting from the mill annealed condition, samples were heated at temperatures between 650-1050 °C for 1 h, then water quenched and subsequently heated at 570 °C for 4 h, air cooled. Finally, the mechanical properties of samples heat treated as indicated above have been obtained.
Downloads
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2005 Consejo Superior de Investigaciones Científicas (CSIC)
This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.
