Influence of the heat treatment on the cold deformation of duplex stainless steels
DOI:
https://doi.org/10.3989/revmetalm.2004.v40.i3.268Keywords:
Duplex stainless steel, sigma phase, compression, twinning, martensiteAbstract
The purpose of this paper is to study the compression behavior of a duplex stainless steel after several annealing conditions, in order to simulate the response during cold rolling in the industrial process. For each studied condition, stress-strain curves present serrations in the flow zone due to austenite and ferrite twinning and the austenite phase transformation to martensite. At the same time, it is shown that sigma phase increases the strength and diminish the cold deformation capacity of the steel.
Downloads
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2004 Consejo Superior de Investigaciones Científicas (CSIC)

This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.