Changes in the elastomechanic constants of cold drawn puré aluminium
DOI:
https://doi.org/10.3989/revmetalm.1998.v34.iExtra.760Keywords:
Elastic constants, Aluminium, Cold drawingAbstract
The changes in the elastic constants at 298 K of polycrystalline samples of pure aluminium (99.5 %) with different levels of cold-working have been determined. The deformation process has been carried out in a tension machine. The properties measured are: Young modulus, E, Poisson ratio, v, and yield strength, σ0,2. The Young modulus diminishes from 70 to 63 GPa for 0-2.5 % deformation (elongation) and then increases with the successive cold-working passes. The Poisson ratio shows a similar behavior whereas the yield strength increases with cold-work. Pure aluminium behavior is similar to that obtained for pure iron (Armco) and for F-1140 annealed steel.
Downloads
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 1998 Consejo Superior de Investigaciones Científicas (CSIC)

This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.