Hot tearing in extruded brass for machining applications
DOI:
https://doi.org/10.3989/revmetalm.0907Keywords:
Brass, Extrusion, Hot tearing, FailureAbstract
Hot tearing failure in 101-mm rods in a direct 20 MN Schlömann press was studied. After the fracture, a zone of fine tearing was observed in the area of the rods with the highest temperature. These fine cracks run in the direction of extrusion and obviously strongly reduced the air and water-tightness properties of the rods. The failure under study appeared in the last stage of solidification, in the temperature range close to the solidus line, which produces an insufficient capacity in the material to absorb tension. Lead condensation, which is the product of a heterogeneous distribution of temperature, is the source of the cracks observed in the rods. Nevertheless, the high temperature of the billet and the low ram speed of extrusion are the main parameters of the failure under study. To avoid this failure, the following is recommended: lower the temperature of the billet to between 660-680 °C and increase the extrusion ram speed to 40 mm/sec. to reduce the extruded die-rod contact time.
Downloads
Download data is not yet available.
References
[1] G. Pantazopoulos and A. Vazdirvanidis, J. Fail. Anal. Prevent. 8 (2008) 218-222. doi:10.1007/s11668-007-9084-7
[2] G. Pantazopoulos, J. Fail. Anal. Prevent 4 (2003) 14-22.
Downloads
Published
2009-12-30
How to Cite
Mannheim, R., & Garin, J. (2009). Hot tearing in extruded brass for machining applications. Revista De Metalurgia, 45(6), 432–438. https://doi.org/10.3989/revmetalm.0907
Issue
Section
Articles
License
Copyright (c) 2009 Consejo Superior de Investigaciones Científicas (CSIC)
This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read here the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.