Physical modeling of steel flow in a tundish equipped with a turbulence inhibitor and a gas curtain

Authors

  • M. Pérez-Labra Instituto Politécnico Nacional, Departamento de Ingeniería Metalúrgica y Materiales
  • M. Díaz-Cruz Instituto Politécnico Nacional, Departamento de Ingeniería Metalúrgica y Materiales
  • J. Palafox-Ramos Instituto Politécnico Nacional, Departamento de Ingeniería Metalúrgica y Materiales
  • E. O. Ávila-Dávila Instituto Politécnico Nacional, Departamento de Ingeniería Metalúrgica y Materiales
  • F. Patiño-Cardona Universidad Autónoma del Estado de Hidalgo, Centro de Investigaciones en Metalurgia y Materiales

DOI:

https://doi.org/10.3989/revmetalm.2005.v41.i6.232

Keywords:

Inclusion, tundish, PIV, gas curtain, RTD, turbulence inhibitor

Abstract


A 2/5 scale model with a transparent plastic sheet was built based on Froude criterion in which eight cases were studied by PIV technique, maintaining a constant gas flow rate of 596 ml/min and only varying the gas curtain position. The results permitted to get Residence Time Distribution (RTD) curves, and from the data processing it was found that combining Turbulence Inhibitor (TI) with the adequate gas curtain position it is enhanced the plug volume. The case VII presented the best results increasing the plug volume in 131.85 % in comparison with the de case IV which was taken as the reference one

Downloads

Download data is not yet available.

Downloads

Published

2005-12-30

How to Cite

Pérez-Labra, M., Díaz-Cruz, M., Palafox-Ramos, J., Ávila-Dávila, E. O., & Patiño-Cardona, F. (2005). Physical modeling of steel flow in a tundish equipped with a turbulence inhibitor and a gas curtain. Revista De Metalurgia, 41(6), 410–418. https://doi.org/10.3989/revmetalm.2005.v41.i6.232

Issue

Section

Articles

Most read articles by the same author(s)