Thermomechanical behaviour of AISI 304 steels
Keywords:Stainless steel, Work hardening, Dynamic recovery and recrystallization, Hot forming,
The hot deformation behaviour of three AISI 304 (H, L and HP) austenitic stainless steel with different carbon contents has been studied. An analysis of the parameters describing their hot flow curves was carried out. No heavy effect of the carbon content was found on most of the latter parameters. However, the work hardening and dynamic recovery behaviour showed clear differences depending on the given alloy, especially at high temperatures and low strain rates where the high carbon steel displayed larger work hardening and dynamic recovery rates than the other steels. The high purity steel (interstitial free) displayed the lower stress levels as its hardening rate was slower than in the other two steels.
Download data is not yet available.
How to Cite
El Wahabi, M., García, V. G., Cabrera, J. M., & Prado, J. M. (2001). Thermomechanical behaviour of AISI 304 steels. Revista De Metalurgia, 37(2), 171–176. https://doi.org/10.3989/revmetalm.2001.v37.i2.460
Copyright (c) 2001 Consejo Superior de Investigaciones Científicas (CSIC)
This work is licensed under a Creative Commons Attribution 4.0 International License.© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read here the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.