Failures in the mould zone which affect to the continuous casting of copper tubes
DOI:
https://doi.org/10.3989/revmetalm.1998.v34.i1.657Keywords:
Defects, Continuous casting, Copper, TubesAbstract
It has been measured the ratio between the refrigerant flow and the casting speed and the appropriate range of this ratio to avoid the advance or delay of the solidification front has been determined. By means of a variable flow of N2 at the exit zone of the copper tubes the improvement of heat transmission in the mould and of the internal surface quality of the cast tubes was achieved.
Downloads
Download data is not yet available.
Downloads
Published
1998-02-28
How to Cite
Rodríguez, J. M., Montecinos, J., Barrera, L., & Yurac, Y. (1998). Failures in the mould zone which affect to the continuous casting of copper tubes. Revista De Metalurgia, 34(1), 39–42. https://doi.org/10.3989/revmetalm.1998.v34.i1.657
Issue
Section
Technical Notes
License
Copyright (c) 1998 Consejo Superior de Investigaciones Científicas (CSIC)
This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read here the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.
