Corrosion behaviour of a sintered 316L steel with different porosity grades
DOI:
https://doi.org/10.3989/revmetalm.1998.v34.iExtra.726Keywords:
Powder metallurgy, Stainless steel, Corrosion tests, PorosityAbstract
AISI 316L sintered samples, with porosities ranging from 9 to 40 %, and without alloying losses at the surface, have been prepared. Those samples, along with conventional (rolled) steel samples, have been subjected to electrochemical and immersion corrosion tests. According to porosity size quantitative measurements, before and after corrosion tests, two corrosion mechanisms, general and pitting, are proposed depending on the initial porosity.
Downloads
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 1998 Consejo Superior de Investigaciones Científicas (CSIC)

This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.