Surface influence of energy absorbed in CO2 laser-aluminium interaction
DOI:
https://doi.org/10.3989/revmetalm.2005.v41.iExtra.996Keywords:
CO2 laser, Aluminium, Absorbed energy, SurfaceAbstract
In this work bead-on-plates tests have been performed with CO2 laser beam, on Al-Mg-Si and Al-Zn-Mg aluminium alloys with different surface treatments. Al-Mg-Si alloy has presented more energy absorbed and best surface finish. The surface treatment with paints has produced an increase of absorbed energy, but with an important porosity in the fusion zone. The increase of surface rugosity has produced an increase of absorbed energy. The chemical treatments previous at bead-on-plates test have produced an important increasing in absorbed energy, especially in Al-Mg-Si alloy.
Downloads
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2005 Consejo Superior de Investigaciones Científicas (CSIC)

This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.