Influence of thermal-spray procedure on the properties of WC-NiCrBSiFe coating
DOI:
https://doi.org/10.3989/revmetalm.2004.v40.i5.286Keywords:
Thermal-spray, cermets, microstructure, high temperature, boilersAbstract
WC-NiCrBSiFe coatings are normally used as protection against heat, corrosion and erosion actions encountered in superheater and reheater tubes in power plant boilers. This coating was thermal-spray projected using different procedures (plasma, HVOF and HFPD) onto stainless steel specimens. The microstructures, porosities, oxide contents and microhardnesses of the coatings were determined. Thermal fatigue tests under simulative power plant service conditions were conducted in an experimental combustion chamber and, finally, the adhesion between the substrate and the coating layer was evaluated by means of tensile tests.The obtained results are discussed, and special attention was paid to the specific characteristics of the different spraying procedures.
Downloads
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2004 Consejo Superior de Investigaciones Científicas (CSIC)
This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.
