Obtaining and characterizing Cu88Sn6,5Zn4Pb1,5 bronze powder for bearing applications
DOI:
https://doi.org/10.3989/revmetalm.2000.v36.i6.595Keywords:
Alloyed bronze powder, Spraying molten metal, Powder metallurgyAbstract
The aim of this work is the development of alloyed bronze powder Cu88Sn6,5Zn4Pb1,5 to substitute the material used in the manufacture of bearings with antifriction properties. The physical and chemical characterization of the powder has been carried out and an experimental 23 design to determine the optimal parameters of the technological process of powder sintering has been used in the specific case of sealed bearing manufacture of the subset shaft-seal of the open cooling compressor.
Downloads
Downloads
Published
How to Cite
Issue
Section
License
Copyright (c) 2000 Consejo Superior de Investigaciones Científicas (CSIC)
This work is licensed under a Creative Commons Attribution 4.0 International License.
© CSIC. Manuscripts published in both the printed and online versions of this Journal are the property of Consejo Superior de Investigaciones Científicas, and quoting this source is a requirement for any partial or full reproduction.
All contents of this electronic edition, except where otherwise noted, are distributed under a “Creative Commons Attribution 4.0 International” (CC BY 4.0) License. You may read the basic information and the legal text of the license. The indication of the CC BY 4.0 License must be expressly stated in this way when necessary.
Self-archiving in repositories, personal webpages or similar, of any version other than the published by the Editor, is not allowed.
